![icnd1 packet tracer labs icnd1 packet tracer labs](https://davidbombal.com/wp-content/uploads/2018/07/CiscoCCNAPacket-Tracer-Ultimate-labsVTP-Configuration-Lab.jpg)
![icnd1 packet tracer labs icnd1 packet tracer labs](https://benisnous.com/wp-content/uploads/2021/08/Cisco-Packet-Tracer-Everything-You-Need-to-Know-800x445.jpg)
A network administrator is reviewing port and VLAN assignments on switch S2 and notices that interfaces Gi0/1 and Gi0/2 are not included in the output. Static routes that use an exit interface will be unnecessary.Ethernet multiaccess interfaces will require fully specified static routes to avoid routing inconsistencies.
![icnd1 packet tracer labs icnd1 packet tracer labs](https://i.ytimg.com/vi/-6WCUMdvGlY/maxresdefault.jpg)
#Icnd1 packet tracer labs serial
Serial point-to-point interfaces will require fully specified static routes to avoid routing inconsistencies.How will a router handle static routing differently if Cisco Express Forwarding is disabled?.incorrectly configured auto-MDIX feature.Which two issues might cause excessive runt and giant frames in an Ethernet network? (Choose two.).The switch interfaces FastEthernet0/2, FastEthernet0/3, and FastEthernet0/4 are configured to not negotiate and should be configured to negotiate..The switch interface FastEthernet0/1 is configured to not negotiate and should be configured to negotiate..The switch interface FastEthernet0/1 is configured as an access interface and should be configured as a trunk interface.The access interfaces do not have IP addresses and each should be configured with an IP address.Inter-VLAN communication between VLAN 10, VLAN 20, and VLAN 30 is not successful. When port security is enabled, a switch port uses the default violation mode of shutdown until specifically configured to use a different violation mode. Which feature on a Cisco router permits the forwarding of traffic for which there is no specific route?.
#Icnd1 packet tracer labs mac
Which MAC addresses will be contained in the S1 MAC address table that is associated with the Fa0/1 port? A ping to PC3 is issued from PC0, PC1, and PC2 in this exact order. Match the packets with their destination IP address to the exiting interface on the router.